|

Opti-Lube Oil Fortifier
|

|
| Dear Opti-Lube: I
am writing this letter to inform you of the benefits we have received
by using your Opti-Lube grease. Since we purchased the Grease
from you several months ago, we have used it in our lube bay to grease
everything from front end and suspension components to pivot pins all
over the trash trucks. Our trucks constantly have severe wear
and galling problems due to the use that they see on a daily
basis. Opti-Lube Grease has substantially decreased virtually
all of these problems since we started using it. We are now
getting almost twice the life out of front end and suspension
components. We no longer have to replace wear bushings and pins
in our hydraulic cylinders and carriages every few months.
As a result of the decreased maintenance, we have saved a
considerable amount of money on parts and repairs. I would
recommend that anybody wanting to save money and extend the life of
their equipment economically, use your product anywhere lubrication is
required.
Sincerely,
John Sovreign.-Maintenance Supervisor
Waste Management of Four Corners |
| Dear Opti-Lube
I wanted to let you know how pleased I am with your product.
I am currently using Opti-Lube at my Mercedes-Benz / BMW service
center and I use it in my race car. Many of my customers have
commented that their fuel mileage has increased and they can feel a
performance gain. In my race car I have experienced similar results in
regards to performance, and have not lost a single engine in two
seasons which is unheard of. Also, front wheel bearing failure while
racing is common because of the high heat caused by severe braking.
Since using your grease in the wheel bearings, I have not lost any
bearings or had a failure.
Again, thank you for such a fine product. I wish you much
success.
Sincerely,
Andre Schagerer, Owner
Tri-Star Motorsports |
| Dear Opti-Lube: I
would like to inform you of the benefits of using your Opti-Lube Oil Fortifier here at
Texaco. Since adding your product to our pickup engines we have found that our gas
mileage has increased by at least 15%.
When added to our natural gas compressor units, we observed that oil
oxidation, nitration and wear particles were reduced in each oil analysis. From our
tests, I feel that the addition of Opti-Lube oil fortifier to our oil has significantly
extended equipment life and reduced fuel consumption thereby saving our company thousands
of dollars.
Sincerely,
Jim Y.-Production Manager
Texaco Exploration and Production |
| Dear Mr. Miller: On October
29, 1997, our steam locomotive developed a hot bearing on the #2 axle on the fireman's
side. After cleaning the axle and bearing, we made the switch to your Opti-Lube block
grease. The number two axle is running much cooler, and other axles which ran at about 120
degrees now run much cooler with your grease, and grease consumption is considerably lower
on the entire engine.
Sincerely,
Roger Stabler
Yolo Shortline Railroad |
| Dear Jim: My company,
Antech Resources & Consulting, is responsible for the servicing and maintenance of the
steam locomotive owned and operated by Alberta Prairie Steam Tours at Stettler, Alberta.
These passenger excursions can be up to 120 miles return with trains as long as 12 cars,
weighing more than 900 tons.
The locomotive is a small 1920 Baldwin 2-8-0 consolidation weighing 114 tons
including tender. The driving axles are equipped with 'Franklin' grease cellars. Main and
side rods have brass bearings throughout. We were having trouble with the journals, and
even some of the drive rods, running warmer than they should at times, regardless of the
grease we used or how often we greased.
Last season we used your block grease in the cellars and in the rod brasses.
We did not have a hot journal reported throughout the entire season. Some of the engine
crews did not grease at all on the run, even on the longest trip.
Yours truly,
John Kvill |
| To Whom It May Concern:
I just wanted to take a moment and let you know how happy I
am to be using your product, OptiLube.
My car is not even 1 year old and since my husband put
OptiLube in it at the end of May, it has never run better! It has
improved my gas mileage, and seems to respond quicker when
accelerating among other things. This is an amazing product.
THANK YOU. OptiLube is now a permanent part of my cars'
maintenance.
Sincerely,
Brandie W.
Bay Networks Senior Administrator |
| Dear Opti-Lube: I am writing to let you know
how very pleased I am with the products purchased from you.
Since July 1995 we have been using Opti-Lube grease in the grease cellars of
our steam locomotives. Compared with the grease we were using before, we are having
excellent results. The locomotive journals are running cooler temperatures and we
are using significantly less grease. As a result, we are having to repack fewer
grease cellars allowing us to put those man hours to use in other areas.
I appreciate your prompt and courteous customer service, as well as your
willingness to customize and find new products to suit our needs.
Sincerely,
Jack Campbell -Chief Mechanical Officer
Cumbres & Toltec Scenic Railroad |
| Dear Opti-Lube: Just a note to let you know
that we are very pleased with the Opti-Lube Oil Fortifier and Opti-Lube grease you supply
us. The Opti-Lube Oil Fortifier has helped us reduce wear in our B & W Pulverizer gear
boxes and both temperature and amperage on the 600 HP motor that drives these gear boxes
have been reduced (amperage was reduced by 4 amps). We have also used the Oil
Fortifier in our lube oil system on our FD & PA fans. Your Grease reduces heat
and amps on precipitator seal air fans to the point that you could touch the bearing
housing, before adding the Grease you could not do this. Amperage on these motors
dropped 4 amps.
The Opti-Lube filter system has saved us thousands of gallons of oil on our
FD, PA, Pulverizer and Boiler Feed Pump lube oil systems by removing water and foreign
particles. This has saved us many oil changes through out units 3 & 4.
Thanks,
Gary McPherson -Craft Supervisor
Public Service Company of New Mexico |
|